I wanted to post a few pictures of the latest device along with a the latest couple of video tests.  These pictures were taken of the latest device but the videos encompass the latest few tests I’ve done.  The last video in this series includes tests from the latest device you will see here.

Test 6: This test shows the new container that I’ve built along with a test run using 4 electrodes of 5/16″ S.S. Threaded Rod. This test uses + - + - on the probes

Test 7: This test is the same as Test 6 except that I’ve switched the electrodes to being + + - -

Test 8: This test is the same as Test 6 Just to try to see which is generating the most bubbles.

Test 9: This test is done only using the 2 center posts instead of dividing the current between 4 posts.

Test 10: This test uses the two center electrodes but with S.S. springs around the bolts to see if the coil shapes of the springs increase our output or not.

Test 11: Same test as 10 but now we’re capturing gas with cap and letting gas leak into water container to see the gas bubbles.

Test 12: This test uses 2 center electrodes but this time we have wrapped 2 pieces of copper wire with fingers that overlap in order to get the electrodes even closer.

Test 13: This test is completely different and uses S.S. Electric switch plates as my electrodes. See pictures below for the design…